Table of Contents
Advertisement
Services
l
l
l
Repeat this step to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the TX54 device:
n
(config)> add service mdns acl interface end value
(config)>
Where value is an interface defined on your device.
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config)> add service mdns acl zone end value
Where value is a firewall zone defined on your device, or the any keyword.
TX54 User Guide
A single IP address or host name.
A network designation in CIDR notation, for example, 2001:db8::/48.
any: No limit to IPv6 addresses that can access the mDNS service.
Display a list of available interfaces:
Use ... network interface ? to display interface information:
(config)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip
defaultlinklocal
lan1
loopback
wan1
wwan1
wwan2
(config)>
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
Enable service discovery (mDNS)
Default IP
Default Link-local IP
LAN1
Loopback
WAN1
WWAN1
WWAN2
611
Advertisement
Table of Contents
