Digi TX54 User Manual page 306

Hotspot
To add domains that can be accessed by the client prior to authentication:
n
a. Click to expand Allowed domains.
b. Click  to add a domain.
c. For Domain, type the hostname of the allowed domain.
d. Repeat to add additional domains.
To add subnets that can be accessed by the client prior to authentication:
n
a. Click to expand Allowed subnets.
b. Click  to add a subnet.
c. For Subnet, type an IPv4 address and optional subnet mask, using the format IPv4_
d. Repeat to add additional subnets.
7. Click Apply to save the configuration and apply the change.

Configure hotspot for RADIUS users authentication from the Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new hotspot
4. Set the authentication mode to radius-users:
(config)> network hotspot hotspot_name auth radius-users
(config)>
5. Configure the RADIUS server:
a. Set the fully qualified domain name or IP address of the primary RADIUS server:
(config)> network hotspot hotspot_name radius primary_radius_server
address
(config)>
b. (Optional) Set the fully qualified domain name or IP address of the secondary RADIUS
server, used if the primary RADIUS server is unreachable:
(config)> network hotspot hotspot_name radius backup_radius_server
address
(config)>
TX54 User Guide
address[/netmask], or the keyword any.
or Enable hotspot using the default
Hotspot configuration
configuration.
306