Table of Contents
Advertisement
Wi-Fi
(config network wifi client new_client)> bgscan_short_interval value
(config network wifi client new_client)>
where value is any integer greater than 0. The default is 1.
d. Set the number of seconds to wait between scans for access points, when the signal
strength from the access point to which the client is currently connected is greater than
the value of bgscan_strength:
(config network wifi client new_client)> bgscan_long_interval value
(config network wifi client new_client)>
where value is any integer greater than 0. The default is 1.
e. Configure the frequencies that will be scanned for available access points.
The TX54 device has three preconfigured frequencies:
n
n
n
You can delete the preconfigured frequencies and add additional frequencies. At least one
frequencies is required.
f. To delete a preconfigured frequencies:
i. Use the show command to determine the index number of the channel to be deleted:
(config network wifi client new_client)> show background_scanning
scan_freq
0 2412
1 2437
2 2462
(config network wifi client new_client)>
ii. Use the appropriate index number to delete the channel. For example, to delete the
2412 frequency:
(config network wifi client new_client)> del 0
(config network wifi client new_client)>
g. To add a frequency:
i. Use the ? with an existing index number to determine the allowed values for
frequencies:
(config network wifi client new_client)> background_scanning scan_
freq 1
Scan frequency: Enable this frequency in the background scan.
Format:
TX54 User Guide
2412 MHz
2437 MHz
2462 MHz
2412
2417
2422
2427
Configure a Wi-Fi client and add client networks
261
Advertisement
Table of Contents
