Digi TX54 User Manual page 74

Interfaces
The default is 60 seconds.
(Optional) Set the amount of time to wait for an initial connection to the interface
l
before this test is considered to have failed:
(config network interface my_wan ipv4 surelink target 0)>
interface_timeout value
0)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes
the format number{w|d|h|m|s}.
For example, to set interface_timeout to ten minutes, enter either 10m or 600s:
(config network interface my_wan ipv4 surelink target 0)>
interface_timeout 600s
(config network interface my_wan ipv4 surelink target 0)>
The default is 60 seconds.
other: Allows you to test another interface's status, to create a failover or coupled
l
relationship between interfaces:
(config network interface my_wan ipv4 surelink target 0)> other
value
(config network interface my_wan ipv4 surelink target 0)>
If other is set:
o
TX54 User Guide
Set the alternate interface to be tested:
i. Use the ? to determine available interfaces:
(config network interface my_wan ipv4 surelink target
0)> other_interface ?
Interface: The network interface.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/lan1
/network/interface/lan_hotspot
/network/interface/loopback
/network/interface/wan1
/network/interface/wwan1
/network/interface/wwan2
Current value:
(config network interface my_wan ipv4 surelink target
0)> other_interface
Wide Area Networks (WANs)
74
(config