How To Recover A Tx54 That Will Not Boot - Digi TX54 User Manual

System administration
4. Click Duplicate Firmware.

Command line
1. Log into the TX54 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Duplicate the firmware:
> system duplicate-firmware
>

How to recover a TX54 that will not boot

This section describes the process for recovering a TX54 device that cannot boot because both
firmware images stored in flash memory have become corrupted.
When a TX54 device is in this state, the device will continually reboot as it attempts to boot one of the
firmware images that are stored on the device. The LED state will be as follows:
Dual-cellular TX54 LEDs
Power
WWAN1 Signal
WWAN1 Service
WWAN2 Signal
WWAN2 Service
To recover the TX54, you will need a TFTP server that has an IP address of 192.168.1.100. The TX54
will use an IP address of 192.168.1.1. Any configuration on the TX54 will not be modified as part of
the recovery process.
Firmware recovery process
1. Download the appropriate TX54 firmware image from
http://ftp1.digi.com/support/firmware/dal/TX54/Latest/.
2. Rename the recovery image to image.bin.
3. Copy the image.bin file into your TFTP server directory.
TX54 User Guide
Single-cellular TX54 LEDs
Power
WWAN Signal
WWAN Service
N/A
N/A
Update system firmware
State
Periodic blink as the device reboots
Off or Yellow or Green
Off or Green
Off or Green
Off or Green
819