Digi TX54 User Manual page 833

System administration
2. Enter the following:
> system factory-erase
3. After resetting the device:
a. Connect to the TX54 by using the serial port or by using an Ethernet cable to connect the
TX54 LAN1 port to your PC.
b. Log into the TX54:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
When you first log into the WebUI or the command line, you will be required the change
the SSIDs and pre-shared keys (passwords) for the preconfigured Wi-Fi access points
before you can save any configuration changes. See
keys for the preconfigured Wi-Fi access points
c. (Optional) Reset the default password for the admin account. See
password for the admin user
Reset the device by using the RESET button.
1. Locate the RESET button on your device.
2. Press the RESET button perform a device reset. The RESET button has the following modes:
Configuration reset:
n
l
l
Full device reset:
n
l
l
3. After resetting the device:
a. Connect to the TX54 by using the serial port or by using an Ethernet cable to connect the
TX54 LAN1 port to your PC.
b. Log into the TX54:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
TX54 User Guide
for further information.
Press and hold the RESET button for 10 seconds.
The device reboots automatically and resets to factory defaults. This does not
remove any automatically generated certificates and keys.
After the device reboots from the first button press, immediately press and holdthe
RESET button for 10 seconds again.
The device reboots again and resets to factory defaults, as well as also removing
generated certificates and keys.
Erase device configuration and reset to factory defaults
Reset default SSIDs and pre-shared
for instructions.
Change the default
833