Digi TX54 User Manual page 86

Hide thumbs Also See for TX54:

Table of Contents

4. Modem are enabled by default. Click to toggle Enable to off to disable.

5. For Active SIM slot, select the SIM slot that should be used by the modem, or select Any to use

any SIM slot. The default is Any.

6. If Active SIM slot is set to Any, for Preferred SIM slot, select the SIM slot that should be

considered the preferred slot for this modem, or select None. In the event of a failover to a

non-preferred SIM, or if manual SIM switching is used to switch to a non-preferred SIM, the

modem will attempt to reconnect to the SIM in the preferred SIM slot. None is the default.

7. For Maximum number of interfaces, type the number of interfaces that can be configured to

use this modem. This is used when using

8. Enable Carrier switching to allow the modem to automatically match the carrier for the active

SIM. Carrier switching is enabled by default.

9. For Access technology, select the type of cellular technology that this modem should use to

access the cellular network, or select All technologies to configure the modem to use the best

available technology. The default is All technologies.

10. For Antennas, select whether the modem should use the main antenna, the auxiliary antenna,

or both the main and auxiliary antennas.

11. Click Apply to save the configuration and apply the change.

Command line

1. Log into the TX54 command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. Depending on the model of the TX54 device, there may be one cellular modem, named either

wwan or wwan1, or there may be two cellular modems, wwan1 and wwan2, which

correspond to each cellular modem. Use the appropriate cellular modem name to configure

the modem. The examples in this section will use the wwan1 modem. Modem configurations

TX54 User Guide

SIMs. The default is 1.

Wide Area Networks (WANs)