Table of Contents
Advertisement
Services
5. Alternatively, you can also delete the usb location source:
a. Click the menu icon (...) next to the usb location source.
b. Click Delete.
6. Click Apply to save the configuration and apply the change.
Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable the USB module:
a. Use the show command to determine the index number of the USB location source:
(config)> show service location source
0
1
(config)>
b. Use the index number to enable or disable the module:
n
TX54 User Guide
enable true
no label
type usb
enable true
no label
type gnss
To enable the module:
(config)> service location source 0 enable true
(config)>
Location information
547
Advertisement
Table of Contents
