Digi TX54 User Manual page 57

Hide thumbs Also See for TX54:

Table of Contents

c. Click IPv6.

d. For Metric, type 2.

5. Click Apply to save the configuration and apply the change.

The TX54 device is now configured to use the cellular modem WWAN, WWAN1 or WWAN, as its highest

priority WAN, and its Ethernet WAN, WAN1, as its secondary WAN.

Command line

1. Log into the TX54 command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. Set the metrics for WWAN or WWAN1:

a. Set the IPv4 metric for WWAN or WWAN1 to 1. For example:

(config)> network interface wwan1 ipv4 metric 1

b. Set the IPv6 metric for WWAN or WWAN1 to 1:

(config)> network interface wwan1 ipv6 metric 1

TX54 User Guide

Wide Area Networks (WANs)