Digi TX54 User Manual page 81

Interfaces

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Configure active recovery on WAN1:
a. Click Network > Interface > WAN1 > IPv4 > SureLink.
b. For Interval, type 10s.
c. Click to expand Test targets.
d. Delete the existing test targets:
Click the menu icon (...) next to each target and select Delete.
e. For Add Test Target, click .
TX54 User Guide
Wide Area Networks (WANs)
81