Digi TX54 User Manual page 664

Applications
},
"properties": {
}
}
>>>
6. Use Ctrl-D to exit the Python session. You can also exit the session using exit() or quit().
Help for the digidevice location module
Get help for the digidevice location module:
1. Log into the TX54 command line as a user with shell access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type shell to access the device shell.
2. At the shell prompt, use the python command with no parameters to enter an interactive
Python session:
# python
Python 3.6.13 (default, May
[GCC 8.3.0] on linux
TX54 User Guide
44.926195299999998,
-93.397084499999999,
273.20001200000002
]
"direction": "None",
"horizontal_velocity": "0.0",
"latitude.deg_min_sec": "44* 54' 45.586\" N",
"longitude.deg_min_sec": "93* 33' 52.334\" W",
"num_satellites": "12",
"quality": "Standard GNSS (2D/3D)",
"selected_source_idx": "0",
"source": "USB (/dev/ttyACM0)",
"source_idx.0.altitude": "273.200012",
"source_idx.0.direction": "None",
"source_idx.0.horizontal_velocity": "0.195489",
"source_idx.0.label": "usb",
"source_idx.0.latitude": "44.902662",
"source_idx.0.latitude.deg_min_sec": "44* 55' 45.065\" N",
"source_idx.0.longitude": "-93.560648",
"source_idx.0.longitude.deg_min_sec": "93* 16' 52.966\" W",
"source_idx.0.num_satellites": "12",
"source_idx.0.quality": "Standard GNSS (2D/3D)",
"source_idx.0.utc_date_time": "Sep-13-2021 8:04:23",
"source_idx.0.vertical_velocity": "0.0",
"source_idx.1.label": "gnss",
"source_idx.1.quality": "No Fix / Invalid",
"state": "Enabled, signal",
"utc_date_time": "Sep-13-2021 8:04:23",
"vertical_velocity": "0.0"
9 2021, 22:49:59)
Digidevice module
664