Digi TX54 User Manual page 45

Configuration and
management
3. Click Network > Wi-Fi > Digi AP (Wi-Fi) (single-Wi-Fi models) or Digi AP (Wi-Fi) (dual-Wi-Fi
models).
4. Enter a new SSID and Pre-shared key.
5. (Dual-Wi-Fi models only): Repeat the above steps for the Digi AP (Wi-Fi2) access point.
6. Click Apply to save the configuration and apply the change.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
TX54 User Guide
Reset default SSIDs and pre-shared keys for the preconfigured Wi-Fi access
points
45