Digi TX54 User Manual page 299

Hotspot
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Create a new hotspot
4. During hotspot configuration, for Authentication mode, select Local shared password .
5. For Local shared password, type the password that all users will be required to enter to
authentication with the hotspot.
6. Click Apply to save the configuration and apply the change.

Configure hotspot for local shared password authentication from the Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new hotspot
4. Set the authentication mode to local-shared-password:
(config)> network hotspot hotspot_name auth local-shared-password
(config)>
TX54 User Guide
or Enable hotspot using the default
or Enable hotspot using the default
Hotspot configuration
configuration.
configuration.
299