Digi TX54 User Manual page 183

Serial port
1. Log into the TX54 WebUI as a user with Admin access.
2. On the menu, click System. Under Configuration, click Serial Configuration.
The Serial Configuration page is displayed.
3.
Note You can also configure the serial port by using Device Configuration > Serial. Changes
made by using either Device Configuration or Serial Configuration will be reflected in both.
4. Click to expand Port 1.
The serial port is enabled by default. To disable, toggle off Enable.
5. For Mode, select one of the following:
Login: Allows the user to log into the device through the serial port.
n
Remote access: Allows for remote access to another device that is connected to the
n
serial port.
Application: Provides access to the serial device from Python applications. See
n
USB serial port
Python to access serial ports
access the serial port.
Modbus: Allows you to use the serial port for Modbus. See
n
UDP serial: Provides access to the device through a UDP serial port. See
n
serial
The default is Login.
6. (Optional) For Label, enter a label that will be used when referring to this port.
TX54 User Guide
for information about creating serial ports in Application mode. See
for information about creating Python applications that
mode.
Configure the serial port
Add a
Use
Modbus gateway.
Configure UDP
183