Digi TX54 User Manual page 258

Wi-Fi
f. Click to expand Scan frequencies list.
The TX54 device has three preconfigured channels that will be scanned for available
access points:
n
n
n
You can delete the preconfigured channels and add additional channels. At least one
channel is required.
g. To delete a preconfigured channel, click the menu icon (...) next to the channel and select
Delete.
h. To add a channel, click Add Scan frequency and select the appropriate channel.
8. Click Apply to save the configuration and apply the change.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new Wi-Fi client:
(config)> add network wifi client new_client
(config network wifi client new_client)>
New access points are enabled by default.
TX54 User Guide
Channel 1 (2412 MHz)
Channel 6 (2437 MHz)
Channel 11 (2462 MHz)
Configure a Wi-Fi client and add client networks
258