Digi TX54 User Manual page 89

Interfaces
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. For single-cellular models, click Network > Interfaces > WWAN or WWAN1 > APN list.
For dual-cellular variants, there are two WWANs, WWAN1 and WWAN2, which correspond to
each cellular modem. Select the appropriate WWAN. For example, to configure the Access
Point Names (APNs) for WWAN1, click Network > Interfaces > WWAN1 > APN list > APN.
4. For APN, type the Access Point Name (APN) to be used when connecting to the cellular carrier.
5. (Optional) IP version:
For IP version, select one of the following:
Automatic: Requests both IPv4 and IPv6 address.
n
IPv4: Requests only an IPv4 address.
n
IPv6: Requests only an IPv6 address.
n
The default is Automatic.
6. (Optional) Authentication method:
For Authentication method, select one of the following:
None: No authentication is required.
n
Automatic: The device will attempt to connect using CHAP first, and then PAP.
n
TX54 User Guide
Wide Area Networks (WANs)
89