Digi TX54 User Manual page 206

Serial port
TX54 User Guide
To limit access to hosts connected through a specified interface on the TX54
n
device:
(config serial USB_port)> add service tcp acl interface end
value
(config serial USB_port)>
Where value is an interface defined on your device.
Display a list of available interfaces:
Use ... network interface ? to display interface information:
(config serial USB_port)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip
defaultlinklocal
lan1
loopback
wan1
wwan1
wwan2
(config serial USB_port)>
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config serial USB_port)> add service tcp acl zone end value
Where value is a firewall zone defined on your device, or the any keyword.
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config serial USB_port)> ... firewall zone ?
Zones: A list of groups of network interfaces that
can be referred to by packet
filtering rules and access control lists.
Additional Configuration
-------------------------------------------------
------------------------------
any
dynamic_routes
edge
Add a USB serial port
Default IP
Default Link-local IP
LAN1
Loopback
WAN1
WWAN1
WWAN2
206