Digi TX54 User Manual page 83

Interfaces
b. Delete the existing test targets:
(config network interface wan1> del ipv4 surelink target 0
(config network interface wan1> del ipv4 surelink target 1
(config network interface wan1)>
c. Add a test target:
(config)> add network interface wan1 ipv4 surelink target end
(config network interface wan1 ipv4 surelink target 0)>
d. Set the probe type to ping:
(config network interface wan1 ipv4 surelink target 0)> test ping
(config network interface wan1 ipv4 surelink target 0)>
e. Set the packet size to 256 bytes:
(config network interface wan1 ipv4 surelink target 0)> ping_size 256
(config network interface wan1 ipv4 surelink target 0)>
f. Set the host to ping:
(config network interface wan1 ipv4 surelink target 0)> ping_host
43.66.93.111
(config network interface wan1 ipv4 surelink target 0)>
1. Repeat the above step for the cellular WWAN1 (wwan1) and WWAN2 (wwan2) interfaces to
enable SureLink on those interfaces.
2. Configure WWAN1 to have priority over WWAN2. The default configurations for WWAN1 and
WWAN2 both have the metric set to 3, while WAN1 has a metric of 1. To configure WWAN1 to
have priority over WWAN2 and continue to be serve as a backup to WAN1, WWAN1's metric
should be set to 2.
a. Type ... to return to the root of the config prompt:
(config network interface wan1 ipv4 surelink target 0)> ...
(config)>
b. Set the metric for WWAN1:
(config)> network interface wwan1 ipv4 metric 2
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
TX54 User Guide
Wide Area Networks (WANs)
83