Digi TX54 User Manual page 99

Interfaces
6. Save the configuration and apply the change:
(config network route policy 1)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure manual carrier selection
By default, your TX54 automatically selects the most appropriate cellular carrier based on the
SIM that is in use and the status of available carriers in your area.
Alternately, you can configure the devices to manually select the carrier, based on the Network PLMN
ID. You can also configure the device to use manual carrier selection and fall back to automatic carrier
selection if connecting to the manually-configured carrier fails.
You can use also use the
and determine their PLMN ID.
Required configuration items
Select Manual or Manual/Automatic carrier selection mode.
n
The Network PLMN ID.
n

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
TX54 User Guide
modem scan command at the command line to scan for available carriers
Wide Area Networks (WANs)
99