Digi TX54 User Manual page 436

Virtual Private Networks (VPN)
b. Set the firewall zone for the OpenVPN server. For TUN device types, this should be set to
internal to treat clients as LAN devices.
(config vpn openvpn server name)> zone value
(config vpn openvpn server name)>
To view a list of available zones:
(config vpn openvpn server name)> firewall zone ?
Zone: The zone for the local TUN interface. To treat clients as LAN
devices this would usually be
set to internal.
Format:
any
dynamic_routes
edge
external
hotspot
internal
ipsec
loopback
setup
Current value:
(config vpn openvpn server name)>
c. (Optional) Set the route metric for the OpenVPN server. If multiple active routes match a
destination, the route with the lowest metric will be used.
(config vpn openvpn server name)> metric value
(config vpn openvpn server name)>
where value is an interger between 0 and 65535. The default is 0.
d. (Optional) Set the range of IP addresses that the OpenVPN server will use when providing
IP addresses to clients:
i. Set the first address in the range limit:
(config vpn openvpn server name)> server_first_ip value
(config vpn openvpn server name)>
where value is a number between 1 and 255. The number entered here will represent
the first client IP address. For example, if address is set to 192.168.1.1/24 and
server_first_ip is set to 80, the first client IP address will be 192.168.1.80.
The default is from 80.
ii. Set the last address in the range limit:
(config vpn openvpn server name)> server_last_ip value
(config vpn openvpn server name)>
TX54 User Guide
OpenVPN
436