Table of Contents
Advertisement
Serial port
a. Enable CTS to monitor CTS (Clear to Send) changes on this port.
b. Enable DCD to monitor DCD (Data Carrier Detect) changes on this port.
9. (Optional) Copy the serial port's configuration by clicking the
The Copy Configuration window displays.
a. For Copy Port 1 configuration to these ports:, type the names of the ports that the
configuration should be copied to.
b. For Copy these settings, select the types of settings that should be copied to the selected
ports.
c. Click Copy.
10. Click Apply to save the configuration and apply the change.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.
Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
TX54 User Guide
Configure the serial port
(copy) icon.
185
Advertisement
Table of Contents
