Digi TX54 User Manual page 133

Interfaces
New LANs are enabled by default. To disable, click Enable.
5. For Interface type, leave at the default setting of Ethernet.
6. For Zone, select the appropriate firewall zone. See
information.
7. For Device, select an Ethernet device, a Wi-Fi access point, or a bridge. See
information about bridging.
8. (Optional) Click to expand 802.1x to configure 802.1x port based network access control:
a. Click to expand Authentication.
b. Click Enable server to enable a 802.1x authentication server.
c. Set the Reauth period.
9. Configure IPv4 settings:
a. Click to expand IPv4.
IPv4 support is enabled by default.
b. For Type, select Static IP address.
c. For Address, type the IP address and subnet of the LAN interface. Use the format IPv4_
address/netmask, for example, 192.168.2.1/24.
d. Optional IPv4 configuration items:
i. Set the Metric.
ii. For Weight, type the relative weight for default routes associated with this interface.
For multiple active interfaces with the same metric, Weight is used to load balance
traffic to the interfaces.
iii. Set the Management priority. This determines which interface will have priority for
central management activity. The interface with the highest number will be used.
iv. Set the MTU.
e. Enable the DHCP server:
i. Click to expand DHCP server.
ii. Click Enable.
See DHCP servers
10. See Configure DHCP relay
11. (Optional) Configure IPv6 settings:
a. Click to expand IPv6.
b. Enable IPv6 support.
c. For Type, select IPv6 prefix delegration.
TX54 User Guide
for information about configuring the DHCP server.
for information about configuring DHCP relay.
Local Area Networks (LANs)
Firewall configuration for further
Bridging for more
133