Table of Contents
Advertisement
Firewall
3. To create an active portal called portal1:
(config)> add firewall portal portal1
(config firewall portal portal1)>
Captive portals are enabled by default. To disable the portal:
(config firewall portal portal1)> enable false
(config firewall portal portal1)>
4. Set the network interface for the portal. Traffic received on this interface's network device will
not be forwarded unless the client has been granted access.
a. Use the ? to determine available interfaces:
(config firewal portal portal1)> interface ?
Interface: The network interface to run the portal on. Traffic
received on this interface's network device will not be forwarded
unless the client has been granted access.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/lan1
/network/interface/lan_hotspot
/network/interface/loopback
/network/interface/wan1
/network/interface/wwan1
/network/interface/wwan2
Current value:
(config firewal portal portal1)> interface
b. Set the interface. For example:
(config firewal portal portal1)> interface /network/interface/wan1
(config firewal portal portal1)>
5. Set the amount of time that a user session remains valid. After the session times out, the user
will be required to log in again.
(config firewall portal portal1)> timeout value
(config firewall portal portal1)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the format
number{w|d|h|m|s}.
For example, to set Session timeout to ten minutes, enter either 10m or 600s:
(config firewall portal portal1)> timeout 600s
(config firewall portal portal1)>
TX54 User Guide
Configure captive portals
774
Advertisement
Table of Contents
