Error Messages On Arms - GRAPHTEC CE7000-40 Service Manual

9.6.4

Error Messages on ARMS

Error
Error Display
code
E04001
E04002
E04003
E04004
E04005
CE7000-UM-251-9370
Cause
Tilt to adjust with AXIS
ALIGNMENT is too large.
The adjusting distance is too
large.
Incorrect data is output.
Failed to adjust the AXIS or
distance.
Incorrect data is output.
It is over the setting range of
the distance adjust.
Incorrect data is output.
When this error was displayed
while scanning the horizontal
line of 1st registration mark.
The base color for scanning
area and the registration mark
detected with same color by
the wrong scanning starting
position.
When this error was displayed
while scanning the horizontal
line of 1st registration mark by
the Auto 1st registration mark
scanning, the media was not
loaded by the SHEET or the
ROLL 1.
When this error was displayed
while scanning the horizontal
line of 1st registration mark by
the Auto 1st registration mark
scanning, there is a printing at
the start position of scanning.
21
9 TROUBLESHOOTING
Solution
Reload the media.
Set correct distance.
Output correct data.
Confirm the adjusting value and the
print size.
Output correct data.
Reset to smaller value.
Output correct data.
Move the tool position to the white
area of first registration mark.
Do not move the tool position onto
the black line of first registration
mark.
Do not move the registration mark
sensor position to the white area of
first registration mark.
Load the media by the SHEET or
the ROLL 1.
Or set the media by the ROOL 2
after the tool position was moved to
the white area of media.
The base color for scanning area
and the registration mark becomes
same when the scanning was
started on the cutting mat.
Do not print anything on the start
position of scanning.