Table of Contents
Advertisement
(8) Remove the four M3L6 binding head screws attaching the right and left Y-belt stopper plates to the
slider.
(9) Detach the Y-belt from the unit.
How to reinstall the Y-belt
(1) Shave 2 to 3 mm off both ends of the Y-belt until the wire comes out as shown below.
(2) Hang the Y-belt on both sides of the pulley.
(3) When the Y-belt is installing to the Y-slider, the four notches of the Y-belt fit into the Y-slider.
CE7000-UM-251-9370
Stopper
M3L6 binding head screw
Y-belt
Shave 2 to 3 mm off both ends of
the Y-belt until the wire comes out.
Y belt
Four notches of the Y-belt fit into
the Y-slider.
7-21
7
DISASSEMBLY AND REASSEMBLY
Y belt
Advertisement
Table of Contents
