Table of Contents
Advertisement
When the adjustment position was not marked adjust the Y drive belt tension by the following
procedure.
(1) Push the belt 2 mm using a force gauge as shown in the picture below.
(2) Adjust the position of Y-motor that Y drive belt is pushed 2 mm by 750 g force for the CE7000-40/60.
Adjust the position of Y-motor that Y drive belt is pushed 2 mm by 500 g force for the CE7000-
130/130AP/160.
(3) Tighten the three M3L6 binding head screws holding the Y motor.
(4) Spread a suitable quantity of the Shinetu silicon grease G501 on the Y-motor pulley.
CE7000-UM-251-9370
CE7000-40/60
CE7000-130/130AP/160
7
DISASSEMBLY AND REASSEMBLY
7-61
Advertisement
Table of Contents
