Table of Contents
Advertisement
Error
Error Display
code
E04005
E04006
E04007
E04009
CE7000-UM-251-9370
Cause
When this error was displayed
while scanning the horizontal
line of 3rd registration mark
when sheet media was loaded
with the ROLL 1 or ROLL 2.
The 3rd registration marks are
not printed in the scanning
area.
When this error was displayed
while scanning the horizontal
line of 4th registration mark
when sheet media was loaded
with the ROLL 1 or ROLL 2.
The 2nd and 3rd registration
marks are not printed in the
scanning area.
When this error was displayed
while scanning the horizontal
line of 4th registration mark.
There is printing object around
the 4th registration mark.
Amount of data has exceeded
the ARMS buffer size for the
registration mark.
Test pattern plotting position is
not within the plotting area for
sensor position adjustment.
This error is displayed when
the 2nd and the 3rd registration
marks of horizontal lines are
not in the scanning area when
the sheet media is loading.
23
9
TROUBLESHOOTING
Solution
Print the 3rd registration mark to the
6 mm inside from the scanning area
(Cutting area).
There is not enough margin from
the horizontal line of 3rd registration
mark to the rear of media edge.
Load the media with the SHEET,
and then confirm it is able to feed
to 6 mm outside from the horizontal
line of 3rd registration mark.
Print the 2nd and 3rd registration
marks to the 6 mm inside from the
scanning area (Cutting area).
There is not enough margin from
the horizontal line of 2nd and 3rd
registration marks to the rear of
media edge.
Load the media with the SHEET,
and then confirm it is able to feed
to 6 mm outside from the horizontal
line of 2nd and 3rd registration
marks.
Do not print any printing object
around the 4th registration mark.
Decrease the data.
Move the media toward center and
plot the test pattern.
Confirm the correct data is sending
to the plotter.
Print the 2nd and the 3rd registration
marks to the 6 mm inside from the
cutting area.
Advertisement
Table of Contents
