Print & Cut Operation - GRAPHTEC CE7000-40 Service Manual

9.4 Print & Cut Operation
Symptom
The horizontal line of 1st
registration mark could
not detect.
The vertical line of 1st
registration mark could
not detect.
CE7000-UM-251-9370
Verification item
When the P&C is starting, did the tool
position move to the center of 1st
registration mark?
Did not the sensor position move to
the center of 1st registration mark?
Was the origin key pressed after the
tool position moved to the center of
1st registration mark?
Was the ROLL 2 set to the rear of 1st
registration mark?
When the 1st registration mark was
scanned by auto scanning, was the
tool on black area?
When the 1st registration mark was
scanned by auto scanning with the
ROLL 2, was the tool on white area
of media?
Was the right side push roller set to at
least 6 mm outside from the vertical
line of 1st registration mark?
When the media was loaded, were
the push roller positions detected?
Move the tool position to the center of
1st registration mark.
Do not move the sensor position to the
center of 1st registration mark.
Do not press the origin key after the
tool position was moved to the center of
1st registration mark when the P&C is
starting.
Set the ROLL 2 at least 6 mm front of 1st
registration, and the tool position must
be onto the white area of media.
Do not print any black object to the
scanning start area.
When the media was loarded with the
ROLL 2, set the ROLL 2 at least 6 mm
front of 1st registration, and the tool
position must be onto the white area of
media.
Set the ROLL 2 at front of 1st
registration, and the tool position must
be onto the white area of media.
Print the vertical line of 1st registration
mark that the right side push roller is
possible to put at least 6 mm outside
from vertical line of 1st registration mark.
Set the push roller detecting function to
"ENABLED".
MENU --> ADV. --> page 4/4 --> 2 PUSH
ROLLER SENSOR --> 1 ENABLED
9-7
9 TROUBLESHOOTING
Solution