Attaching A Tool And A Pen For Ce7000-130Ap - GRAPHTEC CE7000-40 Service Manual

3.2.2

Attaching a Tool and a Pen for CE7000-130AP

Attaching a Tool
When mounting the tool in the tool holder, push the tool all the way into the holder until its flange contacts
the upper part of the holder and then tighten the screw firmly. To prevent injury, avoid touching the tool
immediately after the cutting plotter is turned on or whenever the tool is moving� It is explained here using
cutter pen as an example�
The tool holder is suitable only for use with the cutter plunger� Please refrain from attaching the plotting pen
to it�
Procedure
(1) Loosen the pen holder screw�
CE7000-UM-251-9370
Bracket to hold tool
Tool holder (Forward)
Bracket to hold tool
3 PARTS NAMES and FUNCTIONS
Tool holder
This position of tool holder is
not able to set tool (backward).
Top
Tool holder
Tool holder
Bracket to hold tool
Top
3-11