Table of Contents
Advertisement
(8) Press the F2 key to display the following menu.
(9) Press the F2 key to move the pen carriage to the exchange position.
And then confirm the gap between the 2nd pen holder and the 2nd pen station.
The gap must be 1.1 mm.
When this gap is too far or too close, the 2nd pen will not exchange correctly.
And confirm the height between the 2nd pen holder and the 2nd pen station.
The top of pen holder must be same height.
This gap should be 1.1 mm.
(10) When the gap is not 1.1 mm, press the F3 key to adjust the gap.
Adjust gap using the up or the down position key.
(11) Measure the gap between the 2nd pen holder and the 2nd pen station.
(12) Press the ENTER key when the gap became to 1.1 mm.
(13) When the height is not same height, press the F4 key to adjust the height.
Adjust height using the up or the down position key.
CE7000-UM-251-9370
8-47
8
Electrical Adjustment
Advertisement
Table of Contents
