2.2
Assembling stand and basket to the Plotter
Do not use the electrical screwdriver when tighten the screws, otherwise it will damage the thread of screw.
2.2.1
Assembling stand for the CE7000-60
Procedure
(1) Take out the following parts from the stand packing box.
Stand side bar x 2
Stock shaft x 2
(2) Assemble the left and right stand sides and feet. Insert the four M5L16 cap screws to the thread of the
stand side bar by hand, and then tighten them by hand. Then fasten four M5L16 cap screws by using
the Allen wrench.
CE7000-UM-251-9370
Foot x 2
Stopper x 2
M5L16 Cap screw x 12
2-3
Center bar x 1
Media stocker L and R
M4L20 thumb screw x 4
Allen wrench (for M5 cap screw)
2
Setup