Setting The Number Of Push Rollers (Ce7000-130/160) - GRAPHTEC CE7000-40 Service Manual

Cutting plotter
Hide thumbs Also See for CE7000-40:
Table of Contents

Advertisement

8
Electrical Adjustment

8.18 Setting the Number of Push Rollers (CE7000-130/160)

This will set the number of push rollers.
Perform this procedure if adjustment values could not copy from the SUB-NVRAM when replacing the main
board.
When the main board or the optional push roller was installed, perform this adjustment.
How to set the number of push rollers
(1) Turn on the power while pressing the SLOW and the ENTER keys.
(2) The plotter displays the following menu.
(3) Press the PAUSE/MENU key to display the following menu.
(4) Press the Right position key to display the following menu.
(5) Press the down position key until the following menu is displayed.
(6) Press the F4 key to display the following menu.
(7) Sets the number of push rollers by the Up or Down position key.
CE7000-UM-251-9370
8-55

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CE7000-40 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Ce7000-60Ce7000-130Ce7000-160Ce7000-130ap

Table of Contents