Operation; Media Loading; Loading The Sheet Media - MUTOH VC-600 User Manual

Sign cutting plotter

Hide thumbs Also See for VC-600:

Table of Contents

ValueCut USER MANUAL

4 Operation

To load the media properly, please follow the procedures listed below:

Step 1

Use the lever on the upper right side of the cutting plotter to raise or lower down pinch rollers. Pull the

lever forward until it makes a clicking sound then the pinch rollers are raised ( Figure 4-1 ).

Step 2

Load your media on the platen and slide it under the pinch rollers from either the front side or the

backside. The alignment rulers on the platen extension will help you to adjust the media precisely.

Note:

Be sure that the media must cover

the paper sensors on the platen when

loading the media. At least one of the

two paper sensors (Figure 4-2)

should be covered. Once the media

covers the sensor, the cutting plotter

will size the media width and length

automatically.

V5a 2015 Jan

Lever

Figure 4-1

Paper sensors

Figure 4-2

Operation

Table of Contents

Vc-1300 Vc-1800