Operation; Media Loading; Loading The Sheet Media - MUTOH ValueCut Series User Manual

Valuecut series cutting plotter
Table of Contents

Advertisement

4. Operation

f
4.1

Media Loading

4.1.1 Loading the Sheet Media

To load the media properly, please follow the procedures listed below:
Step 1
Use the lever on the upper right side of the cutting plotter to raise or lower down pinch rollers.
Pull the lever forward until it makes a clicking sound then the pinch rollers are raised (
).
4-1
Step 2
Load your media on the platen and slide it under the pinch rollers from either the front side or
the backside. The alignment rulers on the platen extension will help you to adjust the media
precisely.
Note:
Be sure that the media must
cover the paper sensors on the
platen when loading the media.
At least one of the two paper
sensors (Figure 4-2) should be
covered. Once the media covers
the sensor, the cutting plotter will
size the media width and length
automatically.
Operation
Lever
Figure 4-1
Paper sensors
Figure 4-2
4-1
ValueCut User Manual
Figure

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Valuecut vc-600Valuecut vc-1300Valuecut vc-1800

Table of Contents