Table of Contents
Advertisement
3.3.2
Loading sheet media
Configuration to start from:
Raised pressure rollers.
►
Remove conveyor rolls.
►
Rear media collection bag open and EMPTY.
►
Front media collection bag open when the cutting job is smaller than 4m.
►
Front media collection bag closed when the cutting job is larger than 4m.
Step 1 :
Guide the media under the pressure rollers at the front of the cutter.
Step 2 :
Position the sheet paying attention to the following:
The outer left and the outer right pressure rollers always have to be used. The middle rollers
►
2 and 3 (half of the pressure as roller 1 and 4) can be used, but they may also be disabled (in
between two arrows (as number 2 on the picture below). This to eliminate roller marks on
vulnerable vinyl for example. The left pressure roller can only move between the two flat
arrows.
The cutter will cut between the centres of the outer pressure rollers, regardless of the width
►
of the cut vinyl. Therefore, it is recommended to position the outer pressure rollers about 1cm
inside the media. It is not recommended that the rollers run on the very edge of the material.
Step 3 :
Position the pressure rollers as you have decided in step 2. Pressure rollers 2-3-4 have a tactile
and audible click system which makes it easier to position them correctly. The right pressure
roller (1) can never be malpositioned.
If one of the others is malpositioned, a message will be displayed after media initialization.
Please refer to the picture.
FRONT of the machine
4
P r e s s u r e r o l l 3
m a l p o s i t i o n e d !
Step 4 :
Set the media type to sheet:
3
2
32
User's Guide SC-PRO Cutting Plotter
CHAPTER 3 : BASICS
1
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
