Operation; Media Loading; Loading The Sheet Media - MUTOH ValueCut II VC2-600 User Manual

Operation

4 Operation

4.1 Media Loading

4.1.1 Loading the Sheet Media

To load the media properly, please follow the procedures listed below:
Step 1
Use the lever on the upper right side of the cutting plotter to raise or lower down pinch rollers.
Pull the lever forward until it makes a clicking sound then the pinch rollers are raised. ( Figure 4-1 )
Step 2
Load your media on the platen and slide it under the pinch rollers from either the front side or the
backside. The alignment rulers on the platen extension will help you to adjust the media precisely.
Note:
Be sure that the media must cover
the paper sensors on the platen when
loading the media (The location of
two paper sensors varies by product
model (Figure 4-2). Every ValueCut
has two paper sensors; one in front,
the other one in rear side of the
product). At least one of the two
paper sensors should be covered.
Once the media covers the sensor,
the cutting plotter will size the media
width and length automatically.
Lever
Figure 4-1
Paper Sensor
(VC2-1800)
Paper Sensor
(VC2-600, VC2-1300)
46
ValueCut USER MANUAL
Figure 4-2
VC2E-A-00