Table of Contents
Advertisement
4.1.4
CONTOUR CUTTING key
Please follow the instructions below to select an alignment method, to set parameters and to start contour
cutting.
F
OR MORE INFORMATION ON HOW TO CONTOUR CUT
THE APPLICATION GUIDE DESCRIBING ALL DETAILS ABOUT CONTOUR CUTTING
►
6
CHAPTER
OF THIS MANUAL
►
Step 1 :
Press the [CONTOUR CUTTING] key.
Step 2 :
Select the alignment method with the
C o n t o u r c u t t i n g
M a n u a l
B a r c o d e S i n g l e
B a r c o d e M u l t i
S t a r t :
Step 3 :
Press the [CONTOUR CUTTING]-key to make a selection and continue to the next setting.
Step 4 :
The next screen depends on the previous selection.
a. When you have selected "Manual", the following can be set.
C o n t o u r c u t t i n g
X L e n g t h ( m m )
Y W i d t h ( m m )
R o l l d i r e c t i o n
S t a r t :
Press the [CONTOUR CUTTING]-key to set the X-length. Use the
►
the value. Press the [ ]-key to go to the previous screen.
Adjust the Y-width and roll direction in the same way.
C o n t o u r c u t t i n g
S t a r t :
C o n t o u r c u t t i n g
S t a r t :
C o n t o u r c u t t i n g
S t a r t :
N e x t :
N e x t :
X L e n g t h ( m m )
5 0 0
E x i t :
Y W i d t h ( m m )
5 0 0
E x i t :
R o l l d i r e c t i o n
( N o n ) R e v e r s e
E x i t :
User's Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
,
:
PLEASE REFER TO
- keys and confirm with the
38
.
- key.
keys to change
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
