Service manual Kona cutting plotter
Troubleshooting
6.1
Troubleshooting when no error is displayed
6.1.1
General troubleshooting
Power switch is turned on but the cutting plotter does not operate:
N°
Connect power cable.
1
Check wall outlet.
2
Check if LED LD1G on the mainboard is lit green.
3
Media is present but does not start loading:
N°
Lower the pressure roller lever
1
Clean the media sensors.
2
Check media sensors and lever sensor in diagnostics mode.
3
Check X-motor connection.
4
122
Possible solution
Possible solution
Link
-
-
Mainboard > LED summary on page 73
Link
-
-
Menu overview > Sensors on page 116
X-motor and drive belt on page 33
J7 (X-motor and encoder) on page 72
AP-74380 - Revision 1.1