Setting up the cutter
PREPARING THE CUTTING ENVIRONMENT
The location where you set up your equipment is very important. Please see to it
that it meets following conditions :
♦ Power supply of 100 to 120 VAC 50/60 Hz or 200 to 240 VAC 50/60 Hz.
♦ Ambient Conditions :
•
Operating environment
- Temperature : 5° C to 40° C (41° F to 104° F).
- Humidity : 35% - 75% non-condensing.
•
Recommended environment
- Temperature : Room temperature 16°C to 32°C (61° F to 90° F).
- Humidity : 50% to 65%, non-condensing.
•
Variation rate
- Temperature : 2° C per hour.
- Humidity : 5% per hour.
•
Storage environment
- Temperature : 0° C to 50° C (32° F to 122° F).
♦ Please protect your cutter from moisture, dust, draughts and direct sunlight. It is
best to keep your machine away from open windows and air-conditioners.
♦ See to it that there is an adequate space around the cutter so that ventilation is
not obstructed.
♦ Avoid unnecessary vibrations and set up your cutter on a level surface.
When selecting a place for your cutter, leave at least 150 cm (60") in front and 150
cm (60") at the rear.
Operation Instructions MC-Series cutting plotters
SETTING UP THE CUTTER
1
Page
AP-75020, Rev. 1.0 - 18/12/98