Setting Up Your Kona Cutting Plotter; Tools Necessary; Toolswap Settings - MUTOH Kona User Manual

User's Guide Kona cutting plotter
Through cutting
7.2

Setting up your Kona cutting plotter

7.2.1

Tools necessary

Through cutting is a combination of firmware and software features, the correct settings and
tools. Be sure to have the following firmware, software and tool(s) to perform a through cut.
Firmware - program - tool To have at least ...
Cutter firmware
EasySIGN
Mutoh Grip (+)
Standard knife
Cut through knife
Spare cutting mat
7.2.2

Toolswap settings

Mutoh's supporting cut through technique encodes two cut through methods:
Single tool - cut through tool (1) 

Executes both contour and cut through vector paths with one single knife holder with cut
through knife depth.
Multi-tool - standard (1) & cut through tool (2)

This multi tool method will complete both contour and cut through data with two separated
knife holders. A message on panel will inform the user to swap tools based on the vectors
path identity.
140
1.00
service pack v 5.12
There is a special driver update required when working with
the Kona cutting plotter series cutters. This file (Mutoh.drv) can
be found on
existing Mutoh.drv
8.00
Angle = 45° and offset = 0,50 mm (part number: ZMY-10050B)
Angle = 45° and offset = 0,50 mm (part number: ZMY-10050B)
part number: KY-15305
1
and should be copied over the
Mutoh's FTP
1
2
AP-75380 - Revision 1.2