Cutter Settings & Special Functions; General Procedure To Change Settings On The Cutter; Overview Of General Settings - MUTOH Ultima 850 Operation Instructions Manual

Mutoh Ultima Multi-Purpose Cutting Plotter - Operation Instructions
4. CUTTER SETTINGS & SPECIAL
4.1. GENERAL PROCEDURE TO CHANGE SETTINGS ON THE
CUTTER
Not only there are keys to change or control some values of the Ultima cutting plotter, but more settings are
available by following the instructions mentioned below.
Step 1 : Pressing the [ENTER] key, the user enters the setup-menu.
Step 2 : Pressing the [UP] or [DOWN] key, the user can select the parameter he wants to adjust. Confirm
with the [ENTER] key the selection.
Step 3 : The [UP] key will increase the value or select the next parameter. The [DOWN] key will decrease
the value or select the previous parameter. Press the [ENTER] key to confirm the new setting.
After confirmation the display will show the previous menu.
Notes :
To cancel the changes of the parameter, press the [CANCEL] key. The display will
show the previous value for the selected parameter.
When you press the [EXIT] key the changed value will be ignored and you go back to
the previous menu.
Step 4 : Press the [EXIT] key to go back to the previous menu and confirm the changed settings.

4.2. OVERVIEW OF GENERAL SETTINGS

The general settings parameter influences the cutter's reactions to commands given by the computer or
initiated via the control panel. In the general settings menu, several parameters are available:
→
Sheet Off Mode
→
Pre-Feed Length
→
Page Mode
→
Tool-Up Speed
→
Factory Default
→
Smoothing
→
Language
→
Program Step
→
Communication
→
Sheet Off Margin
→
Max Sheet Length
→
Laser Speed
→
Cut Quality
→
Copies
→
Bezier
→
Emulation
→
VS / AS / ZFf
39
FUNCTIONS
AP-75125, Rev 1.3 ; 20/10/04