Setting Up Connections; Ds1 Line/Management Combination Card - ADC AVIDIA SWD4573I1 User Manual

Setting Up Connections

S U
ETTING P
The following sections list the tasks you need to perform to set up service for these interfaces.

DS1 Line/Management Combination Card

The DS1 line/management card acts as both a line and an AMC card, providing configuration
and management support for the Avidia system as well as eight DS1 uplinks to transmit
subscriber traffic as ATM cells.
You must configure both DS1 and system parameters when configuring the DS1
line/management card. You cannot directly configure a DS1 line/management card using
StarGazer. Instead, the Avidia system containing the DS1 line/management card must first be
subtended to an AV8000 or AV3000 system (see
for information on configuring subtending). Once the system is subtended, you can use in-band
management to configure the DS1 and management parameters.
There are three steps in configuring a DS1 line/management card:
1 Subtend the system containing the DS1 line/management card to an Avidia 8000 or 3000
(see "Subtending Multiple Systems" on page
2 Configure the system boot parameters, trap enablers, and identifiers for the system in which
the DS1 line/management card resides (see
3 Configure the DS1 ports on the DS1 line/management card. See
Service" on page 143
(Web interface).
70
C
ONNECTIONS
(command-line interface) or
"Subtending Multiple Systems" on page 45
45).
"Subtending Multiple Systems" on page
"Configuring DS1 Service" on page 417
Avidia System Configuration and Management User Manual
45).
"Configuring DS1