Displaying The Rip Configuration Table - ADC AVIDIA SWD4573I1 User Manual

[-recv(ripv1|ripv2|v1orv2|donotrecv)]
•
ripv1 — receive RIP Version 1 packets only
•
ripv2 — receive RIP Version 2 packets only
• v1orv2 —
•
donotrecv
[-key <plain text password>]
This parameter enables you to set a password, or key. The password allows the system to
receive RIP table updates from remote routers. RIP updates only occur if the same
password is used by the remote router. The password is used only for RIP version 2 packets;
no password control is available for RIP version 1. Omit this parameter to prevent RIP
updates from remote routers.
The password can be any length and can contain any keyboard character. Avidia supports
only plain text passwords; MD5 password encoding is not supported.
[-auth none]
Include this parameter to disable the key parameter. If no key has been set, this parameter
has no effect.
Example
::rip=> modify 2 -send ripv1c -recv v1orv2 -key admin

Displaying the RIP Configuration Table

To verify a session's RIP configuration, from the ::rip=> prompt, type the show command
as follows then press
show [<ipaddr>]
Parameter
[<ipaddr>]
The IP address of the RIP Configuration Table entry you want to display (format
xxx.xxx.xxx.xxx). Omitting this parameter displays all RIP Configuration Table entries.
Avidia System Configuration and Management User Manual
receive either RIP Version 1 or RIP Version 2 packets
— receive no RIP packets
ENTER .
Chapter 10: Configuring Bridging and Routing
243