Table of Contents
Advertisement
Configuring Frame Relay FRF.5 Circuits
nrt-vbr (non-real-time Variable Bit Rate)—This traffic class carries variable bandwidth.
It is well suited for data services such as frame relay over ATM that requires guaranteed
bandwidth and lower Quality of Service. It is not well suited for LAN traffic due to the
unpredictability of LAN traffic burst size.
rt-vbr (real-time Variable Bit Rate)—This traffic class carries a variable bandwidth. It
is well suited for real-time services such as compressed voice and video that require
stringent cell transfer latency and less bursty traffic. It is not well suited for LAN traffic due
to the unpredictability of LAN traffic burst size.
Example
::frf5=> new 5.1 16 2.1 128 250 -admin up -txlpmode 1 -clpmask 0
-rxlpmode 1 -CIR 0 -Be 144000 -Bc 0 -type ubr
Modifying Frame Relay FRF.5 Circuit Parameters
You can modify a subset of the parameters that you configured when creating the frame relay
circuit.
1
From the ::frf5=> prompt, type show then press
circuits.
2
Note the index number of the frame relay FRF.5 circuit configuration you want to modify.
3
From the ::frf5=> prompt, type the set command in the following format then press
ENTER
.
set <index> [-admin (up|down)] [-txlpmode (1|2)]
[-clpmask (0|1)] [-rxlpmode (1|2)][-CIR <value>]
[-Be <value>] [-Bc <value>]
Parameters
<index>
The index number of the frame relay FRF.5 circuit you want to modify.
[-admin (up|down)]
The administrative status of the line. up activates the port, down deactivates the port.
222
ENTER
to display the configured
Avidia System Configuration and Management User Manual
Advertisement
Table of Contents
