Configuring Bridging and Routing Sessions
[-encap(llc-snap|vcmuxbr|vcmuxrt)]
The encapsulation mode you want to use for this PVC. The type of service specified for the
-service parameter determines the appropriate encapsulation modes. In addition, the
configured encapsulation mode must match the encapsulation mode used by the adjacent
segments in the network.
If you specified service type:
broute
route
bridge
[-stppri <priority>]
Omit this parameter if you specified route or broute for the service type. This
parameter sets the STP priority for the session. The valid range is from 0 to 255, with 0
being the highest priority. The default value is 128.
[-stpcost <cost>]
Omit this parameter if you specified route or broute for the service type. This
parameter sets the STP path cost for the session. The valid range is from 1 to 65535. The
value 1 is the lowest cost, reflecting the greatest efficiency. The default value is 250 for
WAN ports and 100 for LAN ports.
Example
::session=> modify 2 -admin down -subs company123 -service broute
-ipaddr 10.0.1.9 -mask 255.0.0.0 -encap llc-snap -stppri 128
-stpcost 250
232
Set the encapsulation mode to:
llc-snap
llc-snap or vcmuxrt
for SDSL—vcmuxbr
for all other cards—vcmuxbr or
llc-snap
Avidia System Configuration and Management User Manual