Table of Contents
Advertisement
Configuring System Information
Configuring Boot File Information
You must specify the location from which to boot the management card image file. For an
explanation of Avidia image files, see
::system=> prompt, type the boot command in the following format then press
boot (nvram|network) [<file> [<ipaddr>]]
Parameters
(nvram|network)
Specifies the location of the image file you want to boot. Options:
nvram—Boots the specified image file from the management card NVRAM.
network—Boots the specified image file from a network.
[<file>] (This parameter is required if you set the previous parameter to network.)
The complete path and file name of the image file you want to boot, including the file name
extension. If the image file is stored on a TFTP server in a directory other than the default
directory, you must specify the path. See your TFTP server documentation to determine the
required path syntax. If you do not specify the file name, the management card attempts to
boot the available image files in the following order:
1
amc.new—An image file that has been downloaded from a TFTP server but has not
yet been booted or validated. Once the file has been validated, the file name extension
is automatically changed to .bin.
2
amc.bin—The image file that came preinstalled on the management card or an image
file that was downloaded from a TFTP server and has been booted and validated by the
management card.
3
amc.alt—A backup image file you can create prior to downloading a new image file.
[<ipaddr>] (This parameter is required if you set the previous parameter to network.)
The IP address of the TFTP server on the network from which you want to boot the image
file.
Examples
::system=> boot nvram
::system=> boot network amc.bin 10.0.0.121
90
"Avidia System File Management" on page
Avidia System Configuration and Management User Manual
8. From the
ENTER
.
Advertisement
Table of Contents
