Initiating Oc3 Loopbacks; Initiating Ds1 Loopbacks - ADC AVIDIA SWD4573I1 User Manual

Initiating Communication Path Loopbacks

Initiating OC3 Loopbacks

Configure OC3 service from the ::oc3=> prompt. From the ::root=> prompt, type the
following command then press
configuration oc3
From the ::oc3=> prompt, type the set command in the following format then press
set <port> [-loopback (none|local|line)]
The set command is also used to configure OC3 ports. See
Service" on page 142
parameters.
Parameters
[-loopback (none|local|line)]
The type of loopback to start, if any. See the table on
-none to cancel the loopback.
Examples
::oc3=> set 12.1 -loopback line
::oc3=> set 12.1 -loopback none

Initiating DS1 Loopbacks

Configure DS1/DSX-1 channels from the ::ds1=> prompt. From the ::root=> prompt,
type the following command then press
configuration ds1
From the ::ds1=> prompt, type the set command in the following format then press
set <port> [-loopback (none|local|line|payload|remote)]
The set command is also used to configure DS1 ports. See
Service" on page 143
parameters.
346
ENTER
to display the ::oc3=> prompt.
for information about OC3 port configuration
ENTER
to display the ::ds1=> prompt.
for information about DS1 port configuration
Avidia System Configuration and Management User Manual
"Configuring OC3
page 345 for information. Type
"Configuring DS1
ENTER .
ENTER
.