Initiating Ds3 Loopbacks - ADC AVIDIA SWD4573I1 User Manual

Parameters
[-loopback (none|local|line|payload|remote)]
The type of loopback to start. See the table on
cancel the loopback.
Examples
::ds1=> 2.1 -loopback payload
::ds1=> 2.1 -loopback none

Initiating DS3 Loopbacks

Configure DS3 service from the ::ds3=> prompt. From the ::root=> prompt, type the
following command then press
configuration ds3
From the ::ds3=> prompt, type the set command in the following format then press
set <port> [-loopback (none|local|line|remote)]
The set command is also used to configure DS3 ports. See
Service" on page 149
parameters.
Parameters
[-loopback (none|local|line|remote)]
The type of loopback to start. See the table on
cancel the loopback.
Examples
::ds3=> set 12.1 -loopback local
::ds3=> set 12.1 -loopback none
Avidia System Configuration and Management User Manual
Chapter 17: System Maintenance and Administration
page 345
ENTER
to display the ::ds3=> prompt.
for information about DS3 port configuration
page 345
for information. Type none to
"Configuring DS3
for information. Type none to
ENTER
.
347