Configuring SPVCs
Information
Admin Status
Operation Status
Source Slot
Source VPI
Source VCI
Destination Address
Source Tx Traffic Index
Source Rx Traffic Index
Last Release Cause
Retry Failures
Retry Interval
Retry Limit
Deleting SPVCs
From the appropriate ::spvc=> prompt, type the delete command in the following format,
then press
ENTER
delete <slot.port> <vpi> <vci>
194
Description
The SPVC administrative status. Options:
• Up—activated
• Down—deactivated
The SPVC operational status. Options:
• In Progress—attempting to connect
• Connected—operational
• Retries Exhausted—not operational
The channel card slot and port (format slot.port).
The VPI of the VCC between the CPE and the line card.
The VCI of the VCC between the CPE and the line card.
The ATM address of the destination ATM end system.
The traffic descriptor profile index assigned to the SPVC
transmitted traffic.
The traffic descriptor profile index assigned to the SPVC
received traffic.
The reason the SPVC was last disabled. This displays as a
numeric code. See
page 607
for code definitions.
The number of times the system has attempted to restart
non-operational SPVC but failed.
The number of seconds the system waits before attempting
to re-establish the SPVC after a failed call attempt (range: 0 to
3600).
The maximum allowable number of unsuccessful call setup
attempts (range: 0 to 65535).
.
"SPVC Last Release Cause Codes" on
Avidia System Configuration and Management User Manual