Table of Contents
Advertisement
Displaying the Configured OC3 Interface Type
From the ::optics=> prompt, type show then press
following displays.
::optics=> show
*****
THE OC3 CONFIGURATION TABLE FOR PORT 2.1
Loopback Configuration:
*****
THE OC3 CONFIGURATION TABLE FOR PORT 2.2
Loopback Configuration:
C
ONFIGURING
This section contains instructions for configuring service for DS1 line cards installed in either
an Avidia 8000 or an Avidia 3000. To configure a DS1 line/management combination card
installed in an Avidia 2200, you must first subtend the Avidia 2200 to an Avidia 8000 or an
Avidia 3000 using the command-line interface (See
and
"Setting Up Connections" on page 70
management or the command-line interface to configure DS1 service on the DS1
line/management card.
You configure DS1/T1 channels from the ::ds1=> prompt. From the ::root=> prompt,
type the following command then press
configuration ds1
Avidia System Configuration and Management User Manual
Cell Scrambling :
Cell Scrambling :
DS1 S
ERVICE
ENTER
Chapter 7: Configuring Network Services
ENTER
. A screen similar to the
*****
None
Enabled
*****
None
Enabled
"Subtending Multiple Systems" on page 45
for more information). Then, use in-band
to display the ::ds1=> prompt.
143
Advertisement
Table of Contents
